As an Amazon Associate I earn from qualifying purchases.
Installing a load resistor is almost important for the LED lights. You can experience the hyper flash problem with your LED bulbs, and this is the key reason for installing the loading resistance, which is known as equalizer also. Now the question is, what is hyper flash? Hyper flash is where the LED light will flash continuously and rapidly. It is not only a bad looking thing, but the bulb can burn out very fast with this flash. To solve the issue, you need to have a load resistor to stock the harness in the right parallel. Installing the load resistor is a simple process, and there are no positive or negative points here. You are free from the worry about putting wires by matching its right place.
Step by Step Process of Installing a Load Resistor
There are different types of load resistors, and the application process is different for each one. For the single application of filament, you will find two wires only, one negative and one positive. The process is quite straightforward. You just need to tap the wires of your load resistor between two wires of the filament application.
There is the double filament application that comes with three wires of three different modes two positives and one negative. One positive point is for the dim mode, and another one is for blinker or brighter mode. Installing load resistors is quite difficult with the applications. You can tab your load resistor between the brighter color wires or the wires designed for blinker or brighter mode and also with the less bright wires or the negative ones. You can try it through trial and error also. After taping the wires, you can test your LED. If you experience the hyper flashes, you need to take the wires of the resistor out and can tap the wires to another wire. The frequent tests will help you to reach the right place.
If you are still facing the issue of hyper flashing, you need to check the connection. T-tap or quick-tap is the common process of installing a load resistor. Most people think this is easy work, but this process is not that much easier at all. You can also merge the load resistor directly and can stock the harness.
To merge the wires, you can use the stripper, and it will help you to expose all the copper wires in the smaller slit. It will not cause any damage. But if you don’t want to use the stripper, you can scrape it by plastic with a sharp scissor or knife. After connecting the wires, cover it with electrical tape. You need to mount your load resistor only to the metal product and use the zip-ties only but not the double tape.
The Entire Process in a Short Summary
Let’s check the description of the entire process in a short summary:
First, start by merging together all the wires, but to get the right connection, do not use the T-tap. You can also try various combinations for the LED double-filament bulbs. In-proper mounting can cause heat damage, so it is better to mount the load resistor to a metal part. This process is quite easier and can be done within a few minutes only.
There are many load resistor kit available for the LED bulbs online, look for some quick pick. They come in different power and different design too.